Vermont Castings RHEDV25 Installation Instructions & Homeowner's Manual page 23

RHE25SSP & HE25LP Replacement Parts
6
4
Vermont Castings, Majestic Products reserves the right to make
changes in design, materials, specifications, prices and discontinue
colors and products at any time, without notice.
IMPORTANT: Only trim panel assemblies approved
by Vermont Castings, Majestic Products can be
used on these products.
ALL repair parts will be available from your local dealer.
When ordering, always give the following information:
Model and serial number, part description with finish
and part number.
Key Description
1 Trim Frame Black
2 Trim Top Deflector
3 Trim Top Channel (1)
4 Trim Side Channel
5 Trim Top Channel
6 Trim Side Channel
7 Fasteners Package
(Not Shown)
(1) LP trim to be used with SSP trim.
SSP trim dimensions are for openings smaller than
26 " H x 38" W (673mm x 965mm).
LP trim dimensions are for openings smaller than 29" H
x 41" W (736mm x 1040mm).
A2 HE25FP Trim
For use with RHEDV25
HE25FP Flat face louvres with polished window
brass trim
Trim Assembly
1. Remove the front glass (see "Glass Frame Re-
moval" section).
2. Install top and bottom brass trim by using the short-
est black screw. (Fig. 27 & 28)
3. Install bottom decorative plate by simply sliding it
under the unit floor. No fastening is required for this
installation. (Fig. 29) Be sure to remove protective
cover.
10000801
Vermont Castings, Majestic Products RHEDV Direct Vent Insert
5
6
4
3
1
2
FP1289
RHE25SSP HE25LP (1)
10001939 -
55099 -
55077 -
55096 -
- 55097
- 55080
54618 57633
4. Install the bottom louvre assembly by fastening the
hinges with four screws to the pre-punched holes in
the cabinet.
5. Re-install the front glass.
6. Install the top louvre by using the hooks to hang it in
place.
Trim Top
Glass Frame
Trim Bottom
Fig. 27 Install top and bottom brass trim.
Louvre
NOTE: Position brass
trim top as shown (small
end up) to prevent heat
discoloration
Glass Frame
FP1291
Fig. 28 Position brass trim top with small end up.
Bottom
Decorative
Plate
Fig. 29 Slide bottom decorative plate under unit floor.
Screws
FP1290
FP1292
23