Tacony Truvox Multiwash Fault Finding Manual

Model: .............................................................................................................................................................
Serial no: .........................................................................................................................................................
NOTE: Please refer to the machine pictorial in the manual

MACHINE DOES NOT WORK

Has the machine worked before?
Have you charged the battery?
Have you connected the battery correctly?
Check the transport slider is in the UP position?
(Red slider on right hand side from operators position)
Have you switched the battery on?
Give 10 seconds before pressing start pedal.
When the handle is lowered the transport wheels should move up allowing
the brushes to touch the floor, if they don't move then remove the brushes
and shafts and clean.
(Please contact the service desk for more details on removing the side panel)
Does the light come on just above start pedal (i.e. green or red)?
- If the light is green put handle back up and try again
- If the light is red change battery or put on charge for at least 5 and
half hours
- If the red light is flashing please contact service desk

MACHINE IS NOT PICKING UP WATER

Check that the recovery water tray is in correctly
Check that the lip on the recovery tank is not damaged
Check for any broken lugs on the recovery tank
Check the drum is turning
Check that the brushes are not worn.
To extend the brush life use on a lower brush pressure setting.
NO SOLTUION IS SPRAYED ONTO FLOOR
Check you have water in your clean water tank
If your pump is making a loud noise this means there is no water getting to
the pump
V1 – May 2016
FAULT FINDING GUIDE
BATTERY MULTIWASH