Vermont Castings ChateauTM DVT38IN Installation And Homeowner's Manual page 12

Chateau™
�����
����
Screen while de-
pressing ON key
Screen while de-
pressing OFF key
Screen whild de-
pressing OFF key
����
����
Screen after de-
pressing MODE key
12
���
����
Screen after 3 sec-
ond default
����
Screen after 3 sec-
ond default
����
Screen after 3
second default
��� ����
Screen while de-
pressing SET key
Setting ° F / ° C Scale
The factory setting for temperature is ° F. To change this
setting to ° C;
Press the ON H/L key and the OFF CONTINUOUS PILOT
key on the transmitter at the same time. This will change
from ° F to ° C. Follow this same procedure to change from
° C to ° F.
Manual Function
To operate the system in the manual "MODE" do the follow-
ing:
ON - HI Flame Operation
Press and release the ON H/L key. The appliance flame will
come ON and display will show "HI".
ON - LO Flame Operation
Press the ON H/L key. The appliance flame will modulate
down to low flame and display will show "LO".
FP1820
F-C display
Changing Flame Height
9/07
Press and hold the ON H/L key to raise or lower the flame
height.
OFF Operation
Press the OFF Continuous Pilot key and the appliance
flame will shut off. During this time the LCD screen will show
"OF". After 3 seconds, the LCD screen will default to display
room temperature and the word "TEMP" will also show on
the screen. (Flame icon will NOT appear on the LCD screen
in OFF mode)
Thermostat Function
Setting Desired Room Temperature
This remote control system can be thermostatically con-
trolled when the transmitter is in the THERMOSTATIC
mode. To set the MODE and DESIRED room temperature;
Press the MODE key until the LCD screen shows the word
"ROOM". The remote is now in the thermostatic mode.
NOTE: When the word "ROOM" is displayed on the
screen, the transmitter is in the thermostatic mode.
20011956