Advertisement
1) In addition to the items listed in Pole Mount Installation Guide
AP103230-1, you will receive a "diamond" mount adapter plate
attached to a flat adapter plate with your SP1 series antenna.
These plates are shipped in the same box as the antenna, and
packed with the pole mount. You will need a #2 Phillips screw
driver to install the plates.
2) Prior to attaching the mount assembly to the
pole, install mount adapter plates on antenna
as shown. Tighten securely.
Flat Adapter plate: Attach using
(2) 1/4-20 screws, lock washers
and flat washers provided with
antenna. Use holes nearest
edge of plate as shown.
Tighten securely.
3) Proceed with installation and adjustment per
Pole Mount Installation Guide FP103230-1
Mounting Options
To Install for Left Side Pole Mount –
1. Place Antenna on Flat Surface
2. Remove (4) 10-32 screws that attach Antenna Mount to the Flange
3. Carefully rotate Antenna 180 degrees
4. Re-attach Antenna Mount to Flange
5. Drain Hole (Bottom) should be facing the ground (applicable if radome is installed)
To Change Polarization –
1. Remove (4) 8-32 screws that attach the Feed to the Reflector
2. Carefully rotate the Feed 90 degrees
3. Re-install hardware and tighten.
Note:
For Dual Band Antennas, the Feed is factory installed for 2.44GHz Vertical & 5.8GHz Horizontal.
For Single Band Antennas, the Feed is factory installed Vertical Polarization.
FP104780-SP1_revD.docx
"Diamond" Mount
adapter plate attached to
flat adapter plate
Ensure slot
faces away
from antenna.
Page 3 of 5
Advertisement
