Download Print this page

RadioWaves SP1 Series Additional Instructions page 4

Hide thumbs Also See for SP1 Series:

Advertisement

 
SAFETY INFORMATION
This Information May Save You From Death or Injury
Do not attempt to install or dismantle any Radio Waves Inc.
products until you have read and understood the information
and instructions in this document.
Installations:
Only trained professional installers should be used to install or
dismantle antennas, mounts, and related hardware.It is the responsibility of the installer
to be sure that all building and safety codes are met and that the installation is complete
and secure.
Lightning Protection:
and connected correctly to a properly grounded structure. It is the responsibility of the
installer to be sure that the installation is completed in accordance with all applicable
grounding and safety codes.
Electrocution Hazard:
near any type of power line. Should your antenna or related hardware come in contact
with power lines you could be killed! Be sure your installation is out of falling distance
of any overhead wires-including the lead to any building or structure.
NEVER OPERATE OR LOCATE THIS OR ANY EQUIPMENT NEAR POWER LINES
Electrocution Hazard: Portable or Mobile Installation.
If you are installing a Radio Waves Inc. component or part on a portable or mobile
platform such as a Portable Tripod, Mast, Truck, or Van, be sure all safety procedures
are followed and that operators have been properly trained. No one should be allowed
to operate or set up the equipment that has not been properly trained. Radio Waves Inc.
is a component supplier and is not the system designer and has no control over how its
products are used and installed.
It is the responsibility of the System Designer, Van Manufacturer and Owner / Operator
to be sure that the overall system is built in accordance with all applicable design and
safety standards and procedures and that the operators have been properly trained.
NEVER OPERATE OR LOCATE THIS OR ANY EQUIPMENT NEAR POWER LINES
FP104780-SP1_revD.docx
 
 
All antennas and related hardware must be attached to
Do not install or dismantle Radio Waves Inc. products
 
 
 
Page 4 of 5

Advertisement

loading