Advertisement
1) In addition to the items listed in Pole Mount Installation
Guide AP103230-1, you will receive a "diamond" mount
adapter plate with your HP2 series antenna. This plate is
shipped in the same box as the antenna, and packed with
the pole mount. You will need a #2 Phillips screw driver to
install the plate.
2) Prior to attaching the mount assembly to the pole install
"diamond" mount adapter
plate on antenna as shown.
Tighten securely.
3) Proceed with installation and adjustment per Pole Mount Installation Guide AP103230-1
Mounting Options
To Install for Left Side Pole Mount –
1. Place Antenna on Flat Surface
2. Remove (4) 10-32 screws that attach Antenna Mount to the Flange
3. Carefully rotate Antenna 180 degrees
4. Re-attach Antenna Mount to Flange
5. Drain Hole (Bottom) should be facing the ground (applicable if radome is installed)
To Change Polarization –
1. Remove (4) 8-32 screws that attach the Feed to the Reflector
2. Carefully rotate the Feed 90 degrees
3. Re-install hardware and tighten.
NOTE: For Dual Band Antennas, the Feed is factory installed for 2.44GHz Vertical & 5.8GHz
Horizontal.
For Single Band Antennas, the Feed is factory installed Vertical Polarization.
FP104780-HP2_revD.docx
"Diamond" Mount
adapter plate
Mount Adapter plate: Attach
using (4) 1/4-20 screws, lock
washers and flat washers
provided with antenna.
Tighten securely.
Ensure slot
faces away
from antenna
Page 3 of 5
Advertisement
