Omron H8PS Series Manual page 16

2. Setting of Modifying the ON or OFF
Angle
Set or modify with the Angle Keys.
Ex. Set cam number 2 step 2 to turn ON at 30° and turn OFF at 41°.
a. Set the mode switch to PRGM.
b. Set the programming mode switch to MAN.
Mode
PRGM
Initial Display
c. Press the OUT NO. Key and select "2" for cam number 2. Keep
pressing the key for automatic increment or decrement.
d. Press the STEP Key and select "STP2" for step 2.
e. Press the ON/OFF Key to set the ON angle.
f. Press the + or - Keys to set to "30."
g. Press the WRITE Key.
h. Press the ON/OFF Key to set the OFF angle.
i. Press the + or - Keys to set to "41."
j. Press the WRITE Key.
Note: Pressing the + or - Key continually will automatically increment
or decrement the value. Pressing the other key during automat-
ic increment or decrement will increase the speed.
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
Cat. No. M041-E1-04
C-170
Cam Positioner
Programming Mode
In the interest of product improvement, specifications are subject to change without notice.
H8PS
3. Setting or Modifying the ON/OFF
Angle Set or Modify by Teaching
Ex. Set the ON/OFF angle by teaching step 1 of cam number 3.
a. Set the mode switch to PRGM.
b. Set the programming mode switch to TCH.
Mode
PRGM
Initial Display
c. Press the OUT NO. Key and select "3" for cam number 3.
d. Press the STEP Key and select "STP1" for step 1.
e. Press the ON/OFF Key to set the ON angle.
f. Adjust the machine (Encoder) and set it at the output ON position
(125° in the example).
g. Press the WRITE Key.
h. Press the ON/OFF Key to set the OFF angle.
i. Adjust the machine (Encoder) and set it at the output OFF position
(312° in the example).
j. Press the WRITE Key.
Note: If the machine (Encoder) is operated at a speed greater than
permitted, an "E2" error will occur.
Programming Mode