Filling With Water; Switching On And Off; Cleaning - Silvercrest SKAK 1000 A1 Operating Instructions Manual

Filling with water

Notice
Use only mains water for preparing the coffee!
1. Open the water tank lid 1.
2. Fill the glass jug with mains water.
Attention!
• Never fill the water tank 2 with a total volume
of more than 12 cups of mains water. NEVER fill
the water tank 2 with less than 2 cups of water.
Otherwise, the coffee machine could be da-
maged. Use the water level indicator on the
water tank 2.
3. Fill the water tank with the volume of water
required to brew the coffee powder. 2.
For this, use the water level indicator on the
water tank 2.
4. Close the water tank lid 1.

Switching On and Off

• When you are ready to switch the coffee machine
on, place the On/Off switch 5 at the position
"On" (I). The integrated control lamp glows.
The brewing process begins.
• When you are ready to switch the coffee machine
off, place the On/Off switch 5 at the position
"Off" (O). The integrated control lamp goes out.
• Remove the plug from the mains socket if you
are intending to discontinue using the coffee
machine.
Note:
If you do not switch the coffee machine off after the
brewing process is complete, the coffee will be kept
warm on the keep-warm plate 4.
Note:
After you have switched the coffee machine off,
wait at least 10 minutes before you start preparing
a fresh brew.

Cleaning

Risk of electrocution!
Before you clean the Coffee Maker you MUST re-
move the plug from the power socket. Under no
circumstances may the appliance be immersed in
water or held under running water during cleaning.
Risk of burns!
Always wait until the coffee maker has cooled
down before cleaning it.
Attention!
Do not use household detergents or sharp/pointed
objects to remove soiling. These could damage the
appliance.
In order to obtain an optimal taste result from every
brewing process you should clean the coffee machine
after every use.
• Remove the plug from the wall power socket.
• Wipe the housing of the coffee machine and
the glass jug with a soft cloth lightly moistened
with a soapy solution. At the same time remove
any deposits that may have settled in the glass
jug. Afterwards, rinse the glass jug with clean
water.
• You can remove the filter holder 6 for cleaning:
- Open the filter holder 6.
- Lift it slightly and then tilt it in such a way that
the lower bracket is released from the machine.
- Now pull the top bracket down and out of the
machine.
- 5 -