Tape Controls; Pairing A Bluetooth Device - PRESONUS StudioLive III Series Owner's Manual

7

Tape Controls

7.1

Pairing a Bluetooth Device

7 Tape Controls
7.1 Pairing a Bluetooth Device
By default, the Tape channel is sourced from the analog Tape In jacks on the rear
of the mixer and the currently paired Bluetooth audio device simultaneously.
The two signals are mixed together and summed on the Tape In channel.
A note to StudioLive 32SX and 32SC users: Bluetooth audio is not available on
these models.
If you prefer, you can instead route audio from a connected network device,
computer connected via USB, or from tracks 33-34 in a Capture session stored on
an inserted SD card.
To configure the tape input options, press the Edit button in the Tape control area,
next to the Touch Display.
The Tape Edit screen is displayed. Here, you can choose a signal to be routed to the
Tape input channel from the following options:
• Analog/BT. Touch this button to route both the Tape input jacks and the currently
selected paired Bluetooth device to the Tape input channel. When selected, two
slots are shown for paired Bluetooth devices. Touch the button that relates to your
choice of device to route its audio output to the Tape input channel. A Forget
Devices button is provided to break pairing connections, allowing you to pair
another device, or to work out pairing issues with a device that doesn't seem to
function. Bluetooth audio is not available on the StudioLive 32SX and 32SC.
• Network. Touch this button to use audio from the designated network tape
channels as the local tape input source. For more information see Section 5.4.1.
• USB. Touch this button to route audio from a USB-connected computer to the
Tape input channel. Once selected, USB streams 37 and 38 will be available as the
tape source. For more information on USB audio routing,
see Section 6.10.3.
• SD Card. Touch this button to route audio residing on an inserted SD card to the
Tape input channel.
The Tape to Main knob mirrors the setting of the Tape input channel fader. Touch the
knob to adjust this setting with the Master Control encoder.
To pair a Bluetooth audio device for use with the Tape input:
• Press and hold the Bluetooth button in the Tape control area for two seconds
to enter pairing mode.
• The button will flash, indicating that your StudioLive is searching for a
discoverable Bluetooth device.
• Once your device is successfully paired, the Bluetooth button will illuminate
and stop flashing.
Note that while up to two Bluetooth devices can be paired at one time, only one device
can input audio at a time.To remove a device, tap Forget Devices. Bluetooth is not
available on the StudioLive 32SX and 32SC.
StudioLive™ Series III
Owner's Manual
73