Intec CA10 Instruction Manual page 6

Below is a picture of the electrode:
2.1 Installation of the Electrode
2.1.1 1.5" Plumbing
You will need to use a 2" to 1.5" reducer bushing (not provided). Take a hacksaw and
cut approximately 10 inches out of the pipe after the filter. The electrode can be installed
horizontally or vertically. Take the male half of each male union, clean them and then cement
them on the bushing/reducer provided (Figure 3). Then, clean and cement the above assembly
component onto to the remaining pipe ends after your pool filter (Figure 4). Slide in the
electrode and hand tighten the female union to the male union.
Female
Union
Bushing
Reducer
Figure 2
6
Male
Union