Intec CA10 Instruction Manual page 7

Male
Union
2.1.2 2" Plumbing
Take a hacksaw and cut approximately 9.5 inches out of the pipe after the filter (11.5
inches for the commercial double electrode). The electrode can be installed horizontally or
vertically. Take the male half of each union and clean and cement them on the remaining
pipe ends. Slide in the electrode and hand tighten the female union to the male union.
2.2 Connecting the Electronics Unit to the Electrode
Locate the male spades found at each side of the electrode (Page 8; Figure 3). Connect
the female plug located at the end of the wire from the electronics unit and it to the male spade
located on the electrode (Figure 4). Attach the unconnected wire for the electronics unit to the
other side of the electrode (Figure 5). It does not matter which wire plugs into which side of
the electrode. The polarity will alternate the current between the two copper bars on the
electrode. Figure 6 illustrates the proper connection for the electronics unit to the electrode.
Bushing
Reducer
Figure 3
7
Assembly
Component
Female
Union
Figure 4