Intec CA10 Instruction Manual page 15

Setpoint Select
The setpoint on the CV60 will be adjusted using scroll up and scroll down panel pushbuttons
rather than a potentiometer found on the CV50. The DSP will maintain the setpoint value
during power down.
Power On & Off
Power on and off on the CV60 shall be selected via ON and OFF panel pushbuttons rather
than a power toggle switch found on the CV50. The control can automatically power up on if
the P2 option is selected through the Power-up Mode procedure described earlier.
Alert LED
The ALERT LED shall illuminate if any of the E1 to E3 conditions described earlier are
present.
Polarity LED
This LED has the same functionality on the CV50 and CV60 product. The polarity changes
after 10 minutes or when AC power is applied, but not via the ON and OFF buttons. This is a
self-cleaning cycle to keep the cathode and anode clean and reduce the potential of mineral
plating.
15