Low-Pass Crossover - Velodyne VX-10 Owner's Manual

Operational References
A SPEAKER LEVEL INPUT terminals
Connect these input terminals to the speaker output terminals of
your amplifier or receiver.
B SPEAKER LEVEL OUTPUT terminals
The speaker-level signal to the front speakers is output from these
terminals.
C LINE INPUT jacks
Connect these jacks to the LINE OUT jacks of the amplifier.
1

LOW-PASS CROSSOVER

Use this knob to select the high-frequency range at which you wish
to cut-off the signal to the subwoofer.
2 Power indicator
Red: Unit is in standby mode.
Green: Unit is in operation mode.
(automatically turns to STANDBY mode if no signal for 8 min.)
3 PHASE switch
Select the switch position at which you hear a louder bass sound.
4 VOLUME LEVEL knob
Use this knob to adjust the output level of the subwoofer.
5 POWER switch (230V model only)
Main power switch. This switch should be turned in the off position
when the subwoofer is not being used for extended periods of idle time
to extend the life of the subwoofer..
(see Figure 1, Page 8)
9