Low-Pass Crossover - Velodyne DPS-10 User Manual

(1) LOW-PASS CROSSOVER

Use this knob to select the high-frequency range at which you
wish to cut off the signal to the subwoofer. When the knob is
turned all the way to the left, the Subwoofer Direct feature is
invoked and the subwoofer plays all frequencies up to 200 Hz.
(2) PHASE Switch
Allows you to optimize the subwoofer performance for the lo-
cation and your listening position. Select the switch position
at which you hear more bass.
(A) LINE INPUT/LFE Input
Connect these jacks to the LINE OUT preamp output, LFE
output or subwoofer output jack(s) of your receiver/processor.
If using the LFE output from your receiver or processor, plug
the single cable into the "L" – LFE input.
(B) SPEAKER LEVEL INPUT Terminals
Connect these input terminals to the speaker output terminals
of your amplifier or receiver. If you use this method of connec-
tion, when you go to the receiver speaker set up menu, make
sure you select the large speaker option.
Note: Do not use both the LINE INPUT/LFE Input connections and
SPEAKER LEVEL INPUT connections simultaneously.
(C) SPEAKER LEVEL OUTPUT Terminals
Sends a speaker-level signal to the front speakers.
Caution!!!
To avoid damage to your main amplifier, be sure to maintain correct
polarity when making all connections. Red (positive) to red, and
black (negative) to black. Be sure that all connections are tight,
and that there are no loose strands or frayed wires.
Power Switch
The master power switch is located on the lower right half of the
unit. This rocker style switch is the main on/off for the unit. This
switch should be set to position 1 for on (up), 0 for off (down).
6
continued. . .