Table of Contents
Advertisement
3)
Press the
3.2 OBDII/EOBD Diagnostics
Reading Codes
CAUTION: Don't connect or disconnect any test equipment with ignition on
or engine running.
1)
Turn the ignition off.
2)
Locate the vehicle's 16-pin Data Link Connector (DLC).
3)
Plug the OBDII connector to the vehicle's DLC.
4)
Turn the ignition on. But do not start the engine.
5)
Press the
6)
Use the
menu.
7)
Press the
protocols will be observed on the display until the vehicle protocol is
detected.
VS862 - 2 - 151107
EGR Sys. Pass
Heated O2 Pass
O2 Sensor(s)
A/C Pass
Sec. Air Inject Pass
EVAP Sys. Fail
N button to return to previous menus.
Y button. The Main Menu will be observed on the display.
UP/DOWN scroll buttons to select OBDII/EOBD from the
1) VW/AUDI
►2) OBDII/EOBD
3) Oil Service
4) System Setup
Y button. A sequence of messages showing the OBDII/EOBD
Readiness Test
Pass
Main Menu
15
↓
≤ V2.4 SOFTWARE
Advertisement
Table of Contents
