Table of Contents
Advertisement
y
If the scan tool fails to communicate with the selected vehicle's ECU
(Electronic Control Unit), a "LINK ERROR!" message shows up on
the display.
Verify that the ignition is ON;
y
Check if the scan tool's OBD II connector is securely connected to the
y
vehicle's DLC;
Verify that the module is supported;
y
Turn the ignition off and wait for about 10 seconds. Turn the ignition
y
back to on and repeat the procedure from step 5.
y
If the "LINK ERROR" message does not go away, then there might
be problems for the scan tool communicating with the module being
tested. The most common cause is that the scanned module is not
supported on the vehicle.
IMPORTANT - We are constantly improving the operating
of this tool to work with other VAG vehicles. In the event that
your VS862 will not connect to a vehicle or it appears not to
communicate with a specific vehicle type; we recommend that
you download the latest operating software and DTC library
from the Sealey website (www.sealey.co.uk) and update your
VS862 with the latest code and retry your problem vehicle.
y
The numbers (01, 02, 15, 03, 08, etc) in front of the system names refer
to the physical addresses assigned to the systems, not the sequence of
the systems to be arranged.
8)
Read Codes from the Select Function menu and press the Y
Select
button.
VS862 - 2 - 151107
Select System
►01) Engine
02) Auto Trans
15) Airbags
03) ABS Brakes
08) Auto HVAC
09) Cent. Elect.
10
≤ V2.4 SOFTWARE
Advertisement
Table of Contents
