Related Manuals for Walker Edison W44CFD
Summary of Contents for Walker Edison W44CFD
- Page 1 ASSEMBLY INSTRUCTIONS For our most up-to-date instructions, to request missing, lost, or broken parts, or for any other Customer Service issues, please visit our website.
- Page 2 For our most up-to-date instructions, to request missing, lost, or broken parts, or for any other Customer Service issues, please visit our website.
-
Page 3: Parts List
Parts List... -
Page 4: Hardware List
Hardware List * The hardware quantities listed are required for proper assembly. Some extra hardware may have also been included. - Page 5 Step 1 Step 2 Insert dowels (C) and cam bolts (B) into side panels (3 & 4). (Apply glue (D) to dowels as directed in the “General Assembly Guidelines”) Attach support leg (11) to the stand base (2) with screws (E) using hex wrench Attach the legs (5,6,7,8) to the side panels (3 &...
- Page 6 Step 3 Step 4 Attach cam bolts (B) to the middle shelf (9) as shown in the diagram. Insert dowels (C) into the left side panel (3). (Remember to apply glue (D)) Cover cam locks (A) using the provided stickers as shown in the diagram. Insert cam locks (A) into frame assembly.
- Page 7 Step 5 Step 6 Attach cam bolts (B) to side panel assemblies (3 & 4). Insert dowels (C) into the left side panel (3). (Remember to apply glue (D)) Cover cam locks (A) using the provided stickers as shown in the diagram. Insert cam locks (A) into frame assembly.
- Page 8 Step 7 Step 8 Insert dowels (C) into frame assembly. (Remember to apply glue (D)) Slide back panel (14) into the grooves as shown in the diagram. Attach supports (12,13) to the frame assembly as shown in the diagram. Be sure that the side with the warning label is facing outward.
- Page 9 Step 9 Step 10 Insert dowels (C) into frame assembly (remember to apply glue (D)). Attach block (17) to the stand top (1) using screws (V). Screw cam bolts (B) Insert cam locks (A) into frame assembly. into stand top (1), then attach door stop (G) using screws (H) as shown in the Attach right side assembly (4) to the frame assembly.
- Page 10 Step 11 Step 12 Insert the plastic pivots (Q) into the stand as shown in the diagram. Insert dowels (C) into frame assembly. (Remember to apply glue (D)) Insert cam locks (A) into frame assembly. Attach stand top (1) to the frame assembly.
- Page 11 Step 13 Attach door handles (N) to the stand doors (15,16) using screws (P). Attach screws (K) to the corners of each door as shown in the diagram. Attach hinge (J) to door (15) as shown in the diagram. Attach hinge (I) to door (16) as shown in the diagram. Insert lower door hinges (I, J) into the lower pivot points.
- Page 12 Step 14 Insert plastic wedges (R) between the stand frame and the back panel as shown in the diagram. Fasten plastic wedges to the back panel using screws (S).