Velodyne SMS -1 User Manual page 39

2. Raise the volume of the SMS-1 after you have finished your room equalization and
other settings.
RESPONSE" graph as you raise the volume, or,
3. Raise the volume on your subwoofer.
Of course, all hearing is different, so be sure to perform the above step "to taste."
25. Your setup is complete! You are now ready to save settings. You can press the EXIT button
on the remote, or position the cursor over the SAVE/EXIT field on the screen and press
select. The system responds with the following screen:
By pressing the SELECT button, you tell the system to save your settings and return to the
introduction screen. Selecting NO returns without saving (i.e. whatever previous settings were
in effect will be used), and CANCEL keeps you in setup mode.
When the unit saves settings, you will see the video flicker and you may hear a slight tick in your
main speakers. This is normal behavior.
NOTE: The Digital Drive SMS-1 stores all of its settings in internal "Flash" memory. This memory
persists even if the SMS-1 is turned off, loses power, or undergoes a programming update, so
.
you need not worry about losing your customized settings.
w w w . v e l o d y n e . c o m
You can observe this difference by watching the "SYSTEM
Digital Drive User's Manual
33