Advertisement
1 General
Depending on the type and design, WIKORA tanks are suitable for water storage. The maximum working pressure and working
temperature can be found in the technical data.
Set-up, installation and commissioning must be undertaken by a qualified specialist, who must observe these instructions.
The site of installation must be frost-protected according to DIN 4753.
When setting-up and installing the tank, the following regulations should be considered:
In addition to the technical rules in force DIN 1988, DIN 18160, DIN 4753, DIN 4109, DIN 4708, DIN 4751 section 2-4 energy
conservation law and VDE regulations are to be observed. Moreover, the relevant regulations of the suppliers as well as legal
building regulations are to be considered.
2 Transport and installation
In order to prevent damage during transport, the packaging should only be removed at the site of installation. During shipment,
it should be ensured that the tank does not come in contact with any spiky or sharp items, nor is damaged through dropping or
knocks.
During installation, the tank must be disconnected from any humidity carrying components. Moreover, sufficient space for
maintenance and cleaning purposes should be kept free in front of, beside, above and behind the tank.
The pre-assembled PS-jacket can be dismantled for installation. Damages which have been caused in the thermal insulation
during installation must be professionally repaired.
The PS-jacket including rosettes are to be placed at the site of installation before installing the pipeworks.
© Wikora GmbH
Page 2
As of 8/25/2015
Errors excepted.
Advertisement
