Glasdon MODUS 770 Operational/Fixing Instruction Leaflet

MODUS 770 AND MODUS 1280 (ASSEMBLED)
NOTE: Ensure that all relevant personnel read the points listed below and that a copy is passed on to staff involved
with the installation. Please also refer to the 'Manual Handling Operations Regulations 1992' during the
handling of the product and materials used for installation. The total weight of this product is 102kg
(Modus 770) and 119kg (Modus 1280).
REMOVING HOUSING FROM PALLET:
To remove the housing from the pallet rst make sure the housing is in the area where it is to be ground
xed (will be di cult to manoeuvre when o the pallet). Open the door (see Figs1-3) and using a hand drill
remove four screws and washers at the base of each extrusion. Close and lock the door (Figs 5-6) then slide
or lift the housing from the pallet (will require 3-4 people for assistance).
OPENING AND CLOSING HOUSING:
1
Insert Glasdon Key into lock and
turn anticlockwise to unlock the
door. (Alternatively: Turn twist
lock anticlockwise to unlock
door.)
4
Remove wheeled bin from
housing.
NOTE: To allow the wheeled bin to sit inside the housing in the correct position, it is recommended that
the lid of the wheeled bin remains attached and is simply folded over the back of the bin when in use.
For best results please ensure that the front of the wheeled bin is level with the front two extrusions.
TM
OPERATIONAL/FIXING INSTRUCTION LEAFLET
2
Using handle pull door open
to 90 degree position.
5
After replacing the wheeled bin,
remove the door stay catch by
pushing upwards anticlockwise so
that it is positioned vertically.
TM
To ensure that the door remains
open whilst removing the
wheeled bin, turn the door stay
catch clockwise so that it is
positioned horizontally.
Close the door and insert key into
lock. Turn key clockwise to lock
door. (Alternatively: Turn twist lock
clockwise to lock door.)
P. 1
3
6