Glasdon Orion Operating Manual

NOTE: ENSURE THAT ALL RELEVANT PERSONNEL READ THE POINTS LISTED WITHIN THIS LEAFLET AND THAT A COPY
IS GIVEN TO STAFF INVOLVED WITH THE

Opening Shutter/Cover

1.
For a unit with locks, unlock the two padlocks at
the bottom of the shutter and remove. Release
the lock catch from the shutter/cover.

Closing Shutter/Cover

3.
To close, firstly release the lock catches at the base
of the unit so that they are protruding out of the
unit. Using the large handle, pull the shutter
downwards until it is completely closed ensuring
that your feet are not in the way.
IMPORTANT NOTE: The unit has been designed to be located against a wall and there is a recessed area
at the rear of the unit to accept the roller shutter in the open position. Do not place your hands down
See warning sticker on the rear of the unit.
the recess.

Attaching Personalisation Display Stand(s) to the Storage Unit

5.
Align the stand with the four post
mould inserts on top of the storage
unit. Ensure that the 3 off slots on the
stand are facing the front of the unit.
INSTALLATION AND MAINTENANCE OF THIS PRODUCT
2.
Using either the large handle at the bottom of the
shutter/cover or the handle in the centre of the
Rollatec cover, lift upwards until it is completely
open. At the base of the unit lift the two lock
catches so that they are folded neatly inside the unit.
4.
Lift the lock catches upwards to locate with the
bracket on the shutter/cover. Feed the padlock
through the hole in the bracket and lock.
6.
Place M6 x 20mm screw through
M6 x 14mm washer provided
and insert into each of the four
holes. Tighten using your fingers.
7.
Using the 4mm allen key provided
tighten and secure each fixing in
position.
1