Vector Pocket Generator VEC018-AC Owner's Manual & Warranty page 11

CAUTION:
DO NOT CONNECT TO AC DISTRIBUTION WIRING:
The Power Force 50™ is engineered to be connected directly to standard
electrical and electronic equipment in the manner described above. Do not
connect the Power Inverter to household or RV AC distribution wiring. Do not
connect the Power Inverter to any AC load circuit in which the neutral conductor is
connected to ground (earth) or to the negative of the DC (battery) source.
CAUTION:
RECHARGEABLE APPLIANCES
Certain rechargeable devices are designed to be recharged by plugging them
directly into an AC receptacle. These devices may damage the Power Force 50™ .
When first using a rechargeable device, monitor its temperature for the initial ten
minutes of use to determine whether it emits excessive heat. If excessive heat is
detected, it is a good indication that the device should not be used with this
inverter. This problem does not occur with the majority of battery-operated
equipment. Most of these devices use a separate charger or transformer that is
plugged into an AC receptacle. The Power Force 50™ is capable of running most
chargers and transformers.
FUSE REPLACEMENT
If the Power Force 50™ is overloaded, replace the main fuse as follows:
1. Open the top flap of the Pocket Generator™ , carrying case. The main fuse
holder's screw-on/off cap will immediately be visible.
2. Unscrew the fuse holder cap and remove the fuse.
3. Replace with a new 10-amp fuse, if needed.
4. Screw fuse holder cap back on.
5. Close case securely.
Fig. 3.
1 0
1
2
3
4