Advertisement
Common Troubleshooting
8.
Frequently Asked
Question
Device not found!
Connection Started！
PWM signal fault！
Double click to select
the PWM signal, move
the PWM bar and find
the
actuator
response
How
to
restore
original angle value?
Note: the original value
cannot be recovered if it
is
mistakenly set.
Solution
1） Check if the USB cable is loose and causes bad
connection
2)Check if the PC has read the device's
information successfully
3)Check if the power cable is loose and causes
bad connection
1) Check if the Turbo Actuator cable is loose and
causes poor connection
2) Check if the Check if the USB cable is loose
and cause poor connection
3) Check if the PC has read the device's
information successfully
1)
Check if the Turbo Actuator cable is loose
and causes poor connection
2)
Check if you choose the correct Product
has
no
Number. You can try 8 types of Product Number
listed on the user interface.
the
Please select the corresponding G-number of
the product, right-click the selection "Open",
then the product's original angle value will
popup
12
Advertisement
