Siemens CHM 604 MP3 User Manual page 7

CDC603A Aug.06-03
MOUNTING
Caution: Take care not to drill into the fuel tank, the exhaust pipe system, the catalytic
converter or the cables laying behind or below any drilled holes!
MOUNTING IN THE LUGGAGE BOOT
Fix bracket A on the side of the CD changer using the washer screw C(Figs. 7a-c).
1
Fix the base plate with the long bolts H to the bracket using the nut D(Fig.8).
2
If present, lift the carpet covering the floor of the luggage boot(Fig.9).
3
Fix the base plate X2 to the chassis using tapping screw E.The base plate must be
4
fixed to a flat surface.
If there is no flat surface in the luggage boot, a wooden mounting board (approx. 10 mm
thick) under the carpet should be used instead of the base plates. (Fix the wooden
mounting board to the car using three screws). In that case fix the brackets to the board
(laying under the carpet) using screws.
Remove the nuts D. Lift up the CD changer (Fig. 10).
1
Lay the carpet over the base-plates (or the wooden mounting board) and cut four
2
smallcrosses in the carpet.
Check that the three transport screws have been removed from the underside of the
3
CD changer!
Mount the CD changer using the nuts D (Fig. 12).
4
MOUNTING IN SUSPENDED POSITION
The CD changer can also be mounted on the underside of a flat surface, e.g. the rear parcel
shelf.
Fix bracket A to the sides of the CD changer using the washer screw C(Fig.13).
1
Place the CD changer in the mounting position (Fig.14).
2
Mark positions for four mounting holes (with a felt-tip pen).
3
Drill holes of 3.6 mm diameter in the marked positions.
4
Check that the three transport screws have been removed from the underside of the
5
CD changer!
Hold the CD changer in place and attach it with the tapping screws E
6
Press the long bolts through.(Fig.11).
GB
5