Reject A Call (For Handsfree Profile Phones Only); Volume Settings; Reconnect The Interphone - Blueant Interphone none User Manual

Reject a Call (For Handsfree Profile Phones only):

To reject an incoming call just press the MFB(1) for 2 seconds (2
Or, Assuming the InterPhone Voice Answer and Reject is activated, be
silent for 10 seconds. The call will automatically be rejected.
Note: See InterPhone Voice Dial and Reject Activation / Deactivation on page 10
Audio Transfer (For Handsfree Profile Phones only):
During an ongoing call, audio transfer can be made.
From BLUEANT INTERPHONE to Phone:
Press the MFB(1) for 2 seconds (2
the phone.
From Phone to BLUEANT INTERPHONE: Press the MFB(1) for 1 second (1
beep). The audio will be transferred back to the headset.

Volume Settings:

Note: This is for basic volume adjustment once set up. Please see the section in
Special Features on High or Low Volume Mode to set the correct volume range for
your helmet.
Press Volume Up(3) or down(4) button until desired level is reached.
Automatic Volume Adjustment. When the bike is in motion (motorcycle
running and there is driving and background noise): The BLUEANT INTERPHONE
will automatically adjust the volume in response to the background noise. Thus,
the user can continuously hear the audio clearly even when there is loud
background noise.

Reconnect the Interphone:

To reconnect your cell phone to the Interphone after switching off or going out
of range.
1) Turn the Interphone ON and Press the MFB(1) once (first beep)
2) Or, use your phones Bluetooth Menu to connect
nd
beep). The audio will be transferred to
8
nd
beep).
st