Feed Roll Speeds - Delta RC-51 Instruction Manual

FEED ROLL SPEEDS

Your planer is supplied with feed roll speeds of
feet per minute if it is a single phase machine and
28
and feet per minute if it is a three phase machine. When
46
feed roll engagement lever (A) Fig.
the "OUT" position, as shown, the feed rolls are dis­
engaged and the planer will not feed. When feed roll
engagement lever (A) is in the "IN" position, as shown
in Fig. and notch (8) Fig.
14,
of the casting, the feed rolls are engaged and the planer
will feed. To disengage the feed rolls, simply lift up on
engagement lever (A) Fig.
To change feed roll speeds, make sure the feed roll
engagement lever (A) Fig.
position) and open the left side door of the machine. When
belt (C) Fig. is on the smallest step of motor pulley
15,
(D) and the largest step of gearbox pulley (E) the feed roll
speed will be feet per minute on single phase machines
16
and feet per minute on three phase machines. When
25
belt (C) is on the largest step of motor pulley (D) and the
smallest step of gearbox pulley (E) the feed roll speed will
be feet per minute on Single phase machines and
28
feet per minute on three phase machines.
and
16
is all the way in
13,
is engaged with the front
13,
14.
is disengaged (in the out
15,
25
4 6
7
Fig.
13
Fig.
14
Fig.
15