Table of Contents
Advertisement
Installing the Ultrasonic Distance Sensor
Use the female-female connecting wires to connect the Ultrasonic sensor as follows:
Sensor
Vcc
Trig
Echo
GND
The ultrasonic distance
sensor mount is attached to
the servo mount and the
mount is connected to the
servo using double-sided
tape – you can use contact
cement or superglue for
more permanence.
Here are the connections
from the HC-SR04
Ultrasonic Distance Sensor
to the Motor Shield.
Installing the Servo
Arduino
Arduino +5V
Arduino Pin A4
Arduino Pin A5
Arduino GND
24
Arduino Robotics Kit
Advertisement
Table of Contents
Need help?
Do you have a question about the Arduino Robotics Kit With Motor Shield and is the answer not in the manual?