oddWires Arduino Robotics Kit With Motor Shield Manual page 11

Selecting an Uno
Upload the program
Now, simply click the "Upload" button in the environment. Wait a few seconds - you should see the RX and
TX LEDs on the board flashing. If the upload is successful, the message "Done uploading." will appear in
the status bar.
A few seconds after the upload finishes, you should see the pin 13 (L) LED on the board start to blink.
Congratulations! You've got Arduino up-and-running.
If you have problems, please see the troubleshooting suggestions
http://arduino.cc/en/Guide/Troubleshooting).
9
oddWires Arduino Robotics Kit