Installing The Motor Shield - oddWires Arduino Robotics Kit With Motor Shield Manual

Installing the Motor Shield

Snip off 3 x 6 pin strips from the
40 pin header (tip: hold onto the
small piece when you snip so it
doesn't go flying off).
Solder the three strips to the
bottom right hand corner of the
shield where the rows are labeled
A0-A5, GND & 5V. You could
simply solder the connecting wires
later but this way you get to easily
use these pins.
Here's the motor shield installed
on top of the Un. Ensure you
leave the shield evenly positioned.
The USB & Power connections are
a different height; fully inserting
can stress the motor shield board.
20
Installing the Motor Shield Arduino Robotics Kit