Product Identification; Local Codes - Vanguard VSGF28PTC Owner's Operation And Installation Manual

SAFETY
INFORMATION
Continued
16. Operating fireplace above elevations of
4,500 feet could cause pilot outage.
17. To prevent performance problems, do
not use propane/LP fuel tanks of less
than 100 lbs. capacity.
18. Provide adequate clearances around air
openings.
PRODUCT
IDENTIFICATION
Middle Log
Front Log
Front
Burner
Figure 1 - Log Base Assembly, Split Oak Set
Top Louver
Assembly
Fireplace
Hood
Firebox Support
Screen
Assembly
Figure 2 - Fireplace
107156
Crossover
Rear
Log
Log
Rear
Burner
Top Outer
Casing
Optional Blower
Assembly
(Not Included)
Bottom
Louver
Assembly
3
OWNER'S MANUAL

LOCAL CODES

Install and use fireplace with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
UNPACKING
WARNING: Do not remove
the data plates attached to the
heater base assembly. The data
plates contain important warranty
information.
1. With utility knife, cut the carton all the
way around above the staples on the
bottom tray. Lift the carton off the
heater. Remove packing. Note: The
hood is located in the packing on the
right hand side of the heater front. Lift
the heater off the bottom tray.
2. Locate two screws above top corners
of the fireplace screen. Remove and
discard these screws. Lift fireplace
screen up and pull out to remove.
3. Remove protective packaging applied to
logs, log base assembly, and fireplace.
4. Remove fireplace hood from carton
insert.
5. Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought fireplace.
For more information, visit www.desatech.com
1430 Broadway