Keurig DRINKWORKS Home Bar Manual page 15

Drinkworks™ CO Cartridge Install
2
1. Insert full Drinkworks™ CO Cartridge at a 45-degree angle
2
into the receiving end on the drinkmaker*. While holding
the cartridge up at a 45-dgree angle, screw in until the
cartridge is tight and not leaking. If you hear gas leaking
immediately tighten the Drinkworks™ CO
screwing it in until the leaking stops. It is important to get a
tight seal and twist past the hiss.
WARNING: Drinkworks™ CO Cartridge will get colder
2
over time if it is leaking CO . Do not touch cartridge with
2
bare skin while it is leaking.
*NOTE: If the receiving end on the drinkmaker is in the
vertical position, pull it away from the appliance so that
it is at a 45-degree angle.
CAUTION: SHARP NEEDLE. DO NOT PUT FINGERS INTO
CHAMBER WHERE THE CARTRIDGE SCREWS IN.
2. Push down on the cartridge firmly until it locks into place.
The Drinkworks™ CO Cartridge should be completely
2
straight (vertical) when in the correct position.
3. The drinkmaker will Display "CO CARTRIDGE INSERTED
2
CORRECTLY" to confirm that you are ready to make
carbonated beverages.
45°
Cartridge by
2
22
4. Replace the CO Side Door.
2
a.
Slide the front tabs on CO Side Door into their
2
corresponding slots.
b. Pivot the CO Side Door towards the back of the
2
drinkmaker making sure that the front tabs stay
in their corresponding slots.
c. Push on the door until it clicks into place.
5. Ready to make carbonated drinks!
Tutorials & Tips
For tutorials and tips on installing the CO Cartridge, as well as information on where and how to
2
purchase more Drinkworks™ CO Cartridges, refer to the Drinkworks™ App or visit the website
2
www.drinkworks.com.
Disposal
The Drinkworks™ CO Cartridge is a multi-serve single use cartridge. Do not attempt to refill or
2
tamper with it in any way. The Drinkworks™ CO
the cartridge has been used in the drinkmaker it will be fully empty. Please recycle.
For more information visit the website www.drinkworks.com.
Cartridge is recyclable when empty. As long as
2
23