Samsung AC RNJDKG Series Installation Manual page 24

Installation Procedure
Setting the installation options in a batch
1 Make sure that the power is supplied to the indoor unit. If the indoor unit is not plugged in, it must include a power
supply.
2 The panel(display ) should be connected to an indoor unit to receive option.
3 Set the installation option according to the installation condition of an air conditioner.
– The default setting of an indoor unit installation option is "02000-100000-200000-300000".
– Individual control of a remote controller(SEG20) is the function that controls an indoor unit individually when
there is more than one indoor unit.
– No need to assign SEG3, 6, 9, 10, 11, 16, 21, 22, 23, 24 which are non applicable. Even though those segments
are set, they will be ignored.
– If you set the applicable segments with numbers other than the indiciated, the initial setting will be maintained.
4 Set the indoor unit option by wireless remote controller.
Option No. : 02XXXX-1XXXXX-2XXXXX-3XXXXX
Option SEG1
Explanation PAGE
Indication Details
Indication
and details
0
Option SEG7
Explanation PAGE
Indication Details
Indication
and details
1
24
English
SEG2
MODE
Indication Details
A
SEG8
Use of drain pump
Indication Details
0 Disuse
1 Use
Use + 3minute
2
delay
SEG3 SEG4
Use of external
temperature
sensor
Indication Details
RESERVED
0 Disuse
1 Use
SEG9 SEG10
RESERVED RESERVED
SEG5 SEG6
RPM setting
Indoor unit number
compensation
Indication Details 0. Not used
1. High ceiling mode
0 Disuse
2. High ceiling kit
3. Low noise
1 Use
operation mode
SEG11 SEG12
Group address
Indication Details
0
RESERVED
1
slave
master