Samsung AC RNJDKG Series Installation Manual page 22

Installation Procedure
Setting the indoor unit addresses
1 Make sure that the power is supplied to the indoor unit. If the indoor unit is not plugged in, it must include a power
supply.
2 The panel(display ) should be connected to an indoor unit to receive option.
3 Before installing the indoor unit, assign an address to the indoor unit according to the air conditioning system plan.
4 Assign an indoor unit address by wireless remote controller.
– The initial indoor unit ADDRESS is set as "MAIN : 0, RMC : 0".
– Set Main and RMC Address only the setting is required.
– There is no need to assign the indoor unit Main Address if the outdoor unit is addressing automatically.
The indoor unit Main address will follow the outdoor unit's automatically.
– Assign 12 digit when setting the indoor unit address.
– No need to assign SEG4, 5, 8, 10 which are non applicable. Even though those segments are set, they will be
ignored.
– If you set the applicable segments with numbers other than the indiciated, the initial setting will be maintained.
Option No. : 0AXXXX-1XXXXX-2XXXXX-3XXXXX
Option SEG1
Explanation PAGE
Indication Details
Indication
and
0
Details
Option SEG7
Explanation PAGE
Indication Details
Indication
and
1
Details
*SEG6: AJN** models should check maximum installation indoor unit number of outdoor unit.
(Indoor1: 0, Indoor2: 1, ~)
22
English
SEG2 SEG3
Setting Main
MODE
address
Indication Details Indication
No Main
0
A
1
SEG8 SEG9
Setting RMC
address
Indication
0
RESERVED
1
SEG4
Details
RESERVED
address
Main
address
setting
mode
SEG10
Details
No RMC
RESERVED
address
RMC
address
setting
mode
SEG5 SEG6
The unit digit of
an indoor unit
Indication
0~3(ACN*)
RESERVED
0~4
(AJN*)
SEG11 SEG12
Group
Group address
channel(*16)
Indication Details Indication
RMC1 0~2 RMC2
Details
A single
digit
Details
0~F