UTStarcom PPC 6700 User Manual page 10

POWER/Backlight
1
Button
2 MiniSD Card Slot
3 Antenna
4 Notification LED 1
5 Notification LED 2
6 Speaker
7 Touch Screen
8 Left SOFT KEY
9 START Button
10 OK Button
11 Right SOFT KEY
12 END Button
13 NAVIGATION Control
14 TALK Button
15 Infrared Port
16 Internet Explorer
17 Volume
18 Voice Recorder
Press to turn your device on or off. Press and hold to turn the
backlight on or off.
Insert a storage card (MiniSD) for storing data.
Bi-color LED on the left side: Blue and Green for Bluetooth system
notification of powered-up and ready to transmit radio frequency
signal, and Wi-Fi status.
Bi-color LED on the right side: Green and Orange for CDMA standby,
SMS message, CDMA network status, notification, battery charging
status.
Listen to a phone call from here.
Use to write, draw, or make a selection with the stylus.
Press to perform the command shown in the label above the button.
Press to open the Start menu.
Press to verify your data entries, or to exit the program in use.
Press to perform the command shown in the label above the button.
Press to end a call.
Press this multi-directional control up, down, left, or right to move
through menus, program instructions; carry out the selection by
pressing ENTER (the center button).
Press to answer an incoming call or dial a number. Press and hold to
turn speakerphone on or off.
Lets you exchange file(s) or data with other devices wirelessly.
Press to quickly launch Internet Explorer.
Press up or down to adjust the volume.
Press to record a voice note.
|
Getting Started 9