UTStarcom UT-300R2 User Manual page 53

Chapter 5 Advanced Configuration / Network Management
From the Protocol drop-down menu, select the protocol that
you want this rule to apply to. You can select from the TCP,
UDP, ICMP, or Any protocols. If Any is selected, this rule will
apply to any packets that has one of the specified IP addresses
as its source or destination.
You can also specify a range of TCP or UDP ports for this rule
to apply to in the Port Range fields.
The Schedule field allows you to specify when the UT-300R2
router will enable this rule. Click always if you want this rule to
be enabled at all times. Otherwise, click the from radio button
and enter the time and day of the week you want this rule to be
enabled.
Click the Apply button to enter the rule into the IP Filters List
and restart the router.
Directory Configuration and Read-only Menus
This radio button selects the IP address filter rule
IP Filters entry page, which will be displayed when you click
on it.
This radio button selects the MAC address filter
MAC
rule entry page, which will be displayed when you
Filters
click on it.
URL This radio button selects the URL filter rule entry
Blocking page, which will be displayed when you click on it.
This radio button selects the Domain name filter
Domain
rule entry page, which will be displayed when you
Blocking
click on it.
This set of radio buttons allows you to enable or
Status
disable this rule.
You can enter a name for the rule, for easier
Name
identification later.
51