Table of Contents
Advertisement
Chapter 4 Web-based Management
37
Figure 16 Configure LAN IP settings
To change the LAN IP Address or Subnet Mask, type in the
desired values and click the Apply button. The new IP settings
must be saved and the UT-300R2 must be restarted for the
settings to go into effect. To manually Save & Restart the UT-
300R2, click on the Tools directory tab and then click the
System menu button. Then click the Save&Restart button. The
UT-300R2 will save the new IP settings and restart. Your web
browser should automatically be redirected to the new IP
address.
Save New Settings
Most changes that require updating the UT-300R2's non-volatile
RAM will automatically trigger a save and reboot proceedure.
Any changes you have made that you want to be saved to the
UT-300R2's memory can be saved using the System Setting
page, as shown below. To save settings you need to access the
System menu. Click on the Tools directory tab then click the
System menu button to view the menu pictured below.
Advertisement
Table of Contents
