Table of Contents
Advertisement
14
Chapter 3 Before Configuring UT-300R2
Note: If Internet Protocol (TCP/IP) does not display as an
installed component, you must install it.
Set up Proxy Service
In Windows Internet Explorer, you can check if a proxy server is
enabled using the following procedure:
1
Click on the START button, go to Settings and choose
Control Panel.
2
In the Control Panel window, double-click on the Internet
Options icon
3
Click the Connections tab and click on the LAN Settings
button.
4
Verify that the "Use proxy server" option is NOT checked.
If it is checked, click in the checked box to deselect the
option and click OK.
Configure IP Settings on Your PC
To use the web-based management software, launch your web
browser software and use the LAN IP address of the UT-300R2
to access the management software. The default LAN IP
address of the UT-300R2 is used in the Address bar of your
web browser window. Type in http:// followed by the default IP
address, 192.168.1.1 in the address bar of the browser. The
URL in the address bar should read: http://192.168.1.1
Advertisement
Table of Contents
