US Robotics SureConnect 9003 Quick Installation Manual page 18

• If necessary, the Default Gateway data should be at 192.168.1.1.
• To verify these settings, perform the following steps:
Windows 95, 98, or Me Users:
1.
2.
3.
4.
5.
data correct?
6.
Windows NT, 2000, or XP Users:
1.
2.
3.
4.
5.
6.
data correct?
7.
Possible Solution 3:
• Check the connection setting of your Web browser.
• Check that the HTTP Proxy feature of your Web browser is disabled.
Make these checks so that your Web browser can read configuration
pages inside your router.
• Launch your Web browser.
Internet Explorer users:
1.
2.
3.
4.
5.
6.
Netscape Navigator users:
1.
2.
14
Click Windows Start.
Click Run.
Type winipcfg.
Click OK.
Check the IP Address, Subnet Mask, Default Gateway data. Is this
If the data isn't correct, click Release All. Then click Renew All.
Click Windows Start.
Click Run.
Type cmd.
Click OK.
At the DOS prompt, type ipconfig /all.
Check the IP Address, Subnet Mask, Default Gateway data. Is this
If the data isn't correct...
• Type ipconfig /release.
• Press Enter.
• Type ipconfig /renew.
• Press Enter.
Click Tools and then click Internet Options. Then click the
Connections tab.
Select Never dial a connection. Click Apply. Then click OK.
Click Tools again. Then click Internet Options.
Click the Connections tab. Then click the LAN Settings button.
Clear all the check boxes. Click OK.
Click OK.
Click Edit, Preferences, and then double-click Advanced in the
Category window.
Click Proxies, select Direct connection to the Internet, and then