Cisco 1600 Series Installing Or Replacing Manual page 7

Figure 6
Step 3
Step 4
Step 5
Step 6
Proceed with the next section, "Checking the DRAM SIMM Installation."
Checking the DRAM SIMM Installation
After installing the DRAM SIMM, you should verify the installation by reading the messages the
router displays when you power it on:
If the DRAM SIMM is installed correctly, a message similar to the following will be displayed:
Cisco Internetwork Operating System Software
IOS (tm) 1600 Software (C1600-Y-L), Version 11.1(16539)
Copyright (c) 1986-1996 by cisco Systems, Inc.
Compiled Tue 29-Oct-96 21:30 by xxxxx
Image text-base: 0x08019CB4, data-base: 0x02005000
cisco 1600 (68360) processor (revision C) with 9728K/512K bytes of memory.
Processor board ID 01335537
Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
Basic Rate ISDN software, Version 1.0.
Notice that the display shown in bold text indicates how much main memory is installed in the router.
In this example, the router has 10 MB of main memory—the memory stored in the DRAM SIMM
(8 MB) plus the memory stored in the fixed memory chips (2 MB).
Replacing the Cover
Turn the router so that the rear panel is facing you, and replace the two screws that you
removed from the rear panel earlier.
Using both hands to hold the router top and bottom together, turn the router upside down
so that the top of the router is resting on the flat surface. Replace the screw that you
removed earlier from the underside of the router.
Place the router right side up on the flat surface and reconnect all cables to the router.
Turn ON the power by pressing the power switch to the on ( | ) position.
Installing or Replacing the DRAM SIMM in Cisco 1600 Series Routers
Checking the DRAM SIMM Installation
DO NOT INSTALL ANY WAN
MODULE WITH POWER ON
7