Cisco 1600 Series Installing Or Replacing Manual page 5

Installing or Replacing the DRAM SIMM
Take the following steps to install or replace the DRAM SIMM:
Step 1
Figure 4
DRAM SIMM
Step 2
Caution
SIMM carefully.
If the router has a DRAM SIMM already installed, locate it on the system card. With the
rear panel of the router facing you, the DRAM SIMM is located in the upper left corner
of the system card, as shown in Figure 4. If there is no DRAM SIMM installed the router,
proceed to Step 3 to install a DRAM SIMM in the location shown in Figure 4.
DRAM SIMM Location—Cisco 1600 Series Routers
Remove any existing DRAM SIMM. While pulling outward on the tabs to unlatch them,
raise the SIMM to the vertical position and remove it from the SIMM socket.
(See Figure 5.)
To prevent damage, do not push on the center of the DRAM SIMM. Handle the DRAM
Installing or Replacing the DRAM SIMM in Cisco 1600 Series Routers
Installing or Replacing the DRAM SIMM
Rear panel of router
5