Cleaning And Maintenance - Remington T-Series Manual

Step 2: Back of the head
• With the 12mm or 18mm guide comb attached, cut the hair at the back of the head.
Step 3: Side of the head
• With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the
longer 9mm guide comb and continue to cut the top of the head.
Step 4: Top of the head
• Use the longer length fixed combs of 18mm or 25mm to cut hair on top of the head
against the direction in which the hair normally grows.
• Always work from the back of the head.
Step 5: The finishing touches
• Use the trimmer without a comb for close trimming around the base and sides of the
neck.
• To produce a clean straight line at the sideburns, place the trimmer at right angles to
the head, tips of the blades lightly touching the skin and then work downwards.
USING THE FOIL SHAVER
• Fit the foil shaver attachment.
• Use short, well-controlled linear movements. Use your free hand to stretch your skin.
This encourages the hair to stand upright, making it easier to shave.
• Note: always trim your facial hair before shaving.

CLEANING AND MAINTENANCE

Care for your appliance to ensure a long lasting performance. We recommend that you
clean it after each use.
AFTER EACH USE
• Brush any accumulated hairs from the trimmer and attachment heads.
• The easiest and most hygienic way to clean the trimmer is under the tap.
• Place one or two drops of oil on the blades. Turn the appliance on to distribute the
oil evenly, wipe off any excess oil.
REPLACING THE FOILS AND CUTTERS
To ensure continued high quality performance from your shaver, we recommend the foils
and cutters are replaced regularly.
Signs that your foils and cutters need replacing
• Irritation: as foils get worn, you may experience skin irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may feel the
cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the foils.
7