Setting The Tilling Depth; Storage During The Winter Season; Technical Specifications - P.Lindberg 9051583 Original Manual

Setting the tilling depth

The tilling depth depends on the position of the skid
shoes. Adjustment is made by loosening /
disconnecting the bolts, and then raising / lowering
the skid shoes to the desired position. The bolts are
tightened again when the desired height is reached.
Remember to adjust the skid shoes on both sides of
the rotary tiller.

Storage during the winter season

When the season is over, we recommend that you prepare the machine for winter
storage immediately after the last use. Start by cleaning the machine thoroughly – dirt
and dust attracts moisture, and moisture results in rust formation. If you clean the
machine with a high pressure hose, you should avoid directing the stream directly at
the bearings.
After completion of cleaning, the machine should be well lubricated, and the PTO
shaft should be disconnected, and you should smear grease on the bars, and in the
universal joint. Spray the machine with a layer of rust protection oil – especially
important for all polished parts. The machine itself should always be stored indoors,
in a ventilated machine house or garage.

Technical specifications

9051583 – 135 cm
1GN135
Recommended hp: 30 - 45
3-point hitch: Cat. 1
Length: 70 cm
Width: 155 cm
Working width: 135 cm
Height: 80 cm
Working depth, max: 18 cm
Number of blades: 30
Weight: 305 kg
P. Lindberg A/S
Tel: +45 70212626
9051584 – 180 cm
1GN180
Recommended hp: Min. 50
3-point hitch: Cat. 1
Length: 70 cm
Width: 200 cm
Working width: 180 cm
Height: 80 cm
Working depth, max: 18 cm
Number of blades: 42
Weight: 425 kg
4
Sdr. Ringvej 1
DK-6600 Vejen
9058636 – 230 cm
1GN230H
Recommended hp: Min. 75
3-point hitch: Cat. 1 and 2
Length: 83 cm
Width: 250 cm
Working width: 230 cm
Height: 107 cm
Working depth, max: 18 cm
Number of blades: 54
Weight: 520 kg
MAN 9051583_9051584_9058636 EN V3
www.p-lindberg.dk
e-mail: salg@p-lindberg.dk