Advertisement
Available languages
Available languages
Lift the hay rack and fit the skids.
Choose a suitable height and bolt
the skids securely in one of the
three holes (you may choose which
hole to use) using 10 x 60 mm bolts
and nuts.
Next, tighten all of the bolts in the
hay rack.
Fit the gate opposite the three-
point suspension using bolts in one
side and pins in the other side, so
that it can be opened without the
use of a tool.
Either side can be chosen.
Bend out the flap (F), set the chain
on, and then bend the flap in again.
Place the roof sheets on with an
overlap as shown in the drawing.
Bend the ends of the rails for the
roof assembly at the small notches.
P. Lindberg A/S
Tel.: +45 70212626
F
4
Sdr. Ringvej 1
6600 Vejen, Denmark
MAN 9041213 EN V1
www.p-lindberg.dk
E-mail: salg@p-lindberg.dk
Advertisement
