DRAGONFIRE 11-0800 Installation Instructions

DRAGONFIRE 11-0800 Installation Instructions

Universal led chase light, 27”/36” led chase light, black housing

Advertisement

Quick Links

DragonFire Racing
3191 N. Washington St. Suite 2
Chandler, AZ 85225
1 (800) 708-9803
WWW.DRAGONFIRERACING.COM
Off road activities can be hazardous and could lead to injury, dismemberment, paralysis and death. No warranty
of representation is made as to the products ability to protect the user from any injury or death. The user
assumes that risk. The acceptance and /or use of this merchandise purchased from DragonFire by the customer
hereby shall release DragonFire from any and all liability pertaining to the use of such merchandise.
DragonFire Universal LED Chase Light
Part # 11-0800 27" LED Chase Light
Part # 11-0801 36" LED Chase Light
Congratulations on your purchase of the DragonFire Universal LED
Chase Light!
Make sure to check additional DragonFire products for
your UTV at your local Authorized DragonFire Dealer or online at
http://www.DragonFireRacing.com
• Read and understand these instructions before installing product
• Check Local Law/Requirements before use
• Never drive under the influence
Black Housing
Black Housing
.
Disclaimer

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 11-0800 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for DRAGONFIRE 11-0800

  • Page 1 The user assumes that risk. The acceptance and /or use of this merchandise purchased from DragonFire by the customer hereby shall release DragonFire from any and all liability pertaining to the use of such merchandise.
  • Page 2 Part & Hardware List Tools Required Item Description Step Used Phillips Screw Driver Chase Light with Cables Step 2 Digital Multi-Meter/ Test-Light Push Button Cycle Switch Step 6 Rocker Switch Step 5 Socket Wrench Battery Terminals Step 5 Razor Knife 4mm x .7 Screws Step 2 .56”...
  • Page 3 Step 5: Run the Rocker Switch wire harness to the dashboard. Connect the wires to the rocker switch, then install the rocker switch on your dashboard. Recommended hole size for the Rocker Switch is 1.43” x .850”.The rocker switch powers the Chase Light.

This manual is also suitable for:

11-0801

Table of Contents