NETGEAR ProSafe FVS336G Reference Manual page 33

ProSafe Dual WAN Gigabit Firewall with SSL & IPsec VPN FVS336G Reference Manual
A popup window appears, displaying the connection status of WAN port 1.
Figure 2-5
The WAN Status window should show a valid IP address and gateway. If the configuration
was not successful, skip ahead to
this section, or see
Note: If the configuration process was successful, you are connected to the Internet
through WAN port 1. If you intend to use the dual WAN capabilities of the
VPN firewall, continue with the configuration process for WAN port 2.
4. Click the WAN2 ISP Settings tab.
5. Repeat the previous steps to automatically detect and configure the WAN2 Internet
connection.
6. Open the WAN Status window and verify a successful connection
If your WAN ISP configuration was successful, you can skip ahead to
Mode (Required for Dual WAN)" on page
If one or both automatic WAN ISP configurations failed, you can attempt a manual configuration
as described in the following section, or see
Connecting the FVS336G to the Internet
"Manually Configuring the Internet Connection"
"Troubleshooting the ISP Connection" on page
2-11.
"Troubleshooting the ISP Connection" on page
v1.2, June 2008
following
10-4.
"Configuring the WAN
10-4.
2-7