Conversion Loss Using The Frequency Offset Mode; Performing A Power Meter (Source) Calibration Over The If Range; High Dynamic Range Swept Rf/If Conversion Loss; Perform A Power Meter Calibration Over The If Range - Agilent Technologies 8753ET Manual Supplement

Supplement for the User's Guide (Firmware Version 7.68)

Conversion Loss Using the Frequency Offset Mode

Conversion Loss Using the Frequency Offset Mode

Performing a Power Meter (Source) Calibration Over the IF Range

In Step 2 of this section, change the
ADDRESS: P MTR/GPIB

High Dynamic Range Swept RF/IF Conversion Loss

Perform a Power Meter Calibration Over the IF Range

In Step 4 of this section, change the
ADDRESS: P MTR/GPIB

Fixed IF Mixer Measurements

Sequence 1 Setup

Performing a Response Calibration
Change the
PERIPHERAL HPIB ADDR
HIB ADDR
places in this section.
Addressing and Configuring the Two Sources
Change the
PERIPHERAL HPIB ADDR
HIB ADDR
places in this section.

Sequence 2 Setup

Incrementing the Source Frequencies
Change the
PERIPHERAL HPIB ADDR
HIB ADDR
places in this section.
4-4
ADDRESS: P MTR/HPIB
.
ADDRESS: P MTR/HPIB
.
softkey to
softkey to
softkey to
softkey to
softkey to
PERIPHERAL GPIB ADDR
HIB ADDR
PERIPHERAL GPIB ADDR
HIB ADDR
PERIPHERAL GPIB ADDR
HIB ADDR
in two
in three
in two