Advertisement
TrOubleshOOTing
The red led does not start flashing when unit is connected to supply voltage.
• Make sure that the supply voltage is: 230 VAC
all 4 led's starts flashing rapidly.
• Make sure that the SIM card is correctly positioned.
• Check that the SIM cards PIN-code is deactivated or that the PIN-code is set to "0000" or "1111"
(see the section SIM card).
• Make sure that the SIM card is activated and operational by testing the card in an cellular phone.
The call is interrupted directly after being connected.
• Make sure the battery is properly charged. Check voltage with the battery plug disconnected.
call can not be connected. error message from telephone operator.
• To make a call, area code must always be used.
inTerference / pOOr sOund qualiTy.
• Bear in mind that the wiring between GL5 and the lift telephone/ phone is basically a "standard"
PSTN-line and can therefore not be placed in the lifts travelling cable together with high voltage.
*** (Risk of interference)***
• Always place the antenna in an upward position and at least 1,5m distance from GL5.
• Place the antenna where the highest field intensity is obtained according to the table on the unit.
• When a call is connected try placing the antenna in different places to find where the best
receiving/sending position is.
ENGLISH V. 1.1
7
© 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
Service
Advertisement
