Remote Control Unit; Prv-Lx1 - Pioneer PRV-LX1 Operating Instructions Manual

*1 Inputs are compatible with signal levels for both BETA and SMPTE (NTSC only). However, since outputs are
based on DVD format, they differ from BETA and SMPTE levels. As a result, outputs should be used only for
monitoring. See page 34 for input selection methods.
*2 LTC is not supported in drop frame mode.
*3 SONY is a trademark of Sony Corporation. Frame precision is not guaranteed when this unit is used as a
playback unit for editing. This component does not support control from an editing machine.
*4 Functionality of connected devices is not guaranteed. If a USB hard disk drive is not recognized, or if operation
is unstable, change to a hub supporting USB 2.0. If USB mouse and keyboard operation is unstable, try
disconnecting and reconnecting the USB connector. If operation continues to be erratic, inquire your Pioneer
dealer or one of the service centers listed at the end of this manual.
*5 The VGA output connector is provided for future expansion use; at present, the connector does not support the
output of GUI display signals.

Remote Control Unit

STOP
1
REPEAT DISPLAY
2
RPT A-B
3
AUDIO
4
5
ANGLE SUBTITLE
6
MENU
7
TOP
8 MENU
9
SETUP
10
1 2
4 5
7 8
>
0 10
DXX2527
Load batteries into the
remote control unit
Open the rear battery
compartment cover and insert
two AA batteries.
¶ Insert the two batteries with
+ and – polarities aligned as
indicated in the battery case.
Range of Remote Control Unit
When pressing the remote control unit's buttons, point it
toward the front-panel remote sensor. The range of the
remote control unit is about 7 meters, within an angular
range of 30° to either side of the front of the remote
sensor.
¶ The remote control unit may malfunction if strong
sunlight or fluorescent light is allowed to strike the
remote sensor directly.
11
PLAY
12
13
PAUSE
STEP
14
SCAN
15
16
PREV NEXT
17
ENTER
18
19
3 RETURN
TITLE/CHP
6
20
FRM/TIME
21
9
FRM/TIME
22
CLEAR
SEARCH
23
24
No.
1 REPEAT button
2 DISPLAY button
3 RPT A-B button (repeat playback between two
points)
4 AUDIO select button
5 ANGLE button
6 SUBTITLE button
7 MENU button
8 TOP MENU button
9 SETUP menu button *1
10 Number buttons (0–9, >10)
11 STOP button (7)
12 PLAY button (3)
13 PAUSE button (8)
STEP / Slow buttons (e, E)
14
SCAN (fast forward/reverse) buttons (1, ¡)
15
16 Chapter skip NEXT button (¢)
17 Chapter skip PREV button (4)
Cursor buttons (5, 3, ∞, 2)
18
19 ENTER button
20 RETURN button
21 Title, chapter, frame, time button (TITLE/CHP/
FRM/TIME)
22 Frame/time button (FRM/TIME)
23 SEARCH button
24 CLEAR button
*1 This key operates the same as the FUNCTION
button on the main unit.
Note:
¶ Do not mix new batteries with old.
¶ Even batteries of the same type may display different
voltage characteristics. As a result, do not mix batteries
of different brands together.
¶ If you do not plan to use the remote control unit for an
extended period (one month or more), remove the
batteries from the remote control unit to prevent potential
damage from leakage of battery fluid. If battery leakage is
discovered, remove and discard the batteries, and
carefully wipe up any battery fluid from inside the
compartment. Replace the old batteries with new.
¶ When disposing of used batteries, please comply with
governmental regulations or environmental public
instruction's rules that apply in your country or area.
¶ This remote control unit cannot be used for recording
operations (recording start/pause/stop).
Names of Parts
Name

PRV-LX1

17
En