Repair
Pump Installation
1. Ensure locknut (431) is screwed on pump with flat
side up. Grease pump mounting threads in plate
(412) with lithium grease. Screw pump into pump
mounting plate (401) until top of pump thread is
above mounting plate 1/2 to 1 1/2 threads above
flush.
2. Align pump rod hole with link hole. Push retaining
pin (436) in. Pull retaining wire down to cover pin
ends.
3. Reconnect fluid inlet (Q) and outlet (M).
Q
454,
455
4. Tighten locknut (431) by hitting firmly with a
non-sparking hammer.
14
5. For Iso A pump only: reconnect two tubing lines (N)
from ISO Pump Lube reservoir. Flush and refill res-
ervoir with TSL 206995.
412
431
6. Refill Resin B pump wet cup with TSL 206995.
M
7. Reconnect fan wires if they were disconnected.
8. Reinstall air motor cover and tighten two screws (E).
452
ti8456a
N
ti8487a
E
ti8455a
311512A