Table of Contents
Advertisement
P/N 3003960_A
CLEANING UNDER DISPLAY PAN
Remove all product from the merchandiser
and place in cooler. Always disconnect electri-
cal power before cleaning.
1. Remove the display pan
2. Use non-abrasive cleaning materials and a
mild detergent to clean display pan.
3. Wipe down the insides of the merchandiser
with a mild detergent, and replace display
pan. Allow merchandiser to pull down in
temperature before loading product.
CLEANING EVAPORATION PAN
The condensate water outlet for self
contained models empties into a limited
capacity evaporation pan.
Debris or dirt accumulation inside the conden-
sate evaporation pan or on the heater coil will
reduce the pan's evaporation capacity and
cause premature heater failure. The evaporation
pan waste water will overflow and spill onto the
floor if the heater is not properly operating.
Remove accumulated debris from the evapora-
tion pan. Wipe down heater coil with a cloth
and warm water. Be sure to remove any dirt,
debris or liquids from the heater coil.
Water introduced during cleaning will cause
the evaporation pan to overflow.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
and poses risk of bodily injury
gloves and protective eye wear when servicing.
Turn off evaporation pan heater, and allow
pan to cool.
CLEANING COILS
Condenser coils should be cleaned at least
once per month. Additional cleaning may be
needed depending on the operational environ-
ment. A dirty condenser blocks normal airflow
through the coils.
Fan
Evaporation Pan is Hot!
GSVM 4060F Merchandisers
4-3
–
Always wear
Advertisement
Table of Contents
